TSGL: : mouse troubles

[Tilman Brandl]

Chuck,

a few thoughts on this:

- remove the mouse and let it reinstall during bootup (if you haven't done 
so already), reboot and check
- try booting in protected mode - if it doesn't change the mouse settings 
there, it could be any of the programs/utilities/drivers that are starting 
during or immediately after boot.
- using any of the startup control utilities out there, remove all 
unnecessary programs from autostart, then reboot and if the mouse is fine, 
try to add them to startup again one after another.

Not sure whether this may help ...

Tilman

----- Original Message ----- 
From: "Chuck Neuenschwander" <annandchuck at yahoo.com>
To: "Tech Support Guy Mailing List" <list at tsgserver.com>
Sent: Sunday, March 30, 2008 3:51 PM
Subject: TSGL: : mouse troubles


> made a mistake. This computer is  Win2K, not WinXP
>
>
> Chuck Neuenschwander <annandchuck at yahoo.com> wrote:
>
> WinXP, Dell latitude laptop
> Every time I boot my mouse scroll is set to maybe two lines.
> I go to Ctrl Panel / Mouse
> under Hardware I select my Basic MS Optical Mouse 1.0A
> I click on Scrolling
> and see on the Slide Bar it is way down towards the bottom.
> I move it up to the middle, and click on Apply
> and OK
> then if I repeat Mouse/Scrolling it is still set OK
> Then if I use it, all is OK, a page at a time...
> BUT next time I boot the computer, it goes back to two lines at a time
> and I have to go through the whole operation again.
> What can be resetting the scrolling each time I boot up and how do I fix 
> it?
> Any ideas? -chuck